SimTek FP72X72EBRN Guía de instalación descargar pdf (Pagina 11)

Step #3: Gate Hardware Installation

A. Thread the ½” hinge rod into the upper and lower inserts in the gate metal

frame leaving about 1 ½” from the edge of the gate to the bracket (this can

be re-adjusted later)

B. Next hold the gate and its hinges against the gate post at the proper position

and height. Drill the provided 2 ½” self-tapping screws into the gate post.

Do not over tighten the screws because it can crush the

internal foam, making an indentation in the post.

C. Level the gate. The standard height should be level with the top of the fence

panel. Gates are designed with a 4” gap at the bottom to facilitate an un

obstructed swing. If you desire a gap smaller than 4”, you may lower the

gate relative to the fence panels.

D. Attach the striker rod to the gate by using the provided button head screws.

E. Finally, align the latch with the striker rod and attach the latch to the end

post by using the supplied 2 ½” self-tapping screws.

Internal

Metal Frame

Illustration A

Hinge

Gate Panel

2 ½” Zinc Plated Self Tapping Screw

SimTek Hinge

Striker Rod

Button Head Screw

Latch

2 ½” Zinc Plated Self Tapping Screw

1.866.648.9336 www.simtekfence.com

1 2 ... 6 7 8 9 10 11 12

Sin comentarios

SimTek FP72X72EBRN Guía de instalación Pagina 11